Ideas For Install Flush Mount Ceiling Light
Flush mount ceiling light– Flush-mount ceiling lights are a common way to brighten any room. The higher the ceiling, the higher flush-mount ceiling lamp install, creating a wider spread of light from the fixture. Remove the lighting circuit at the main breaker panel, turn off the power switch. Confirm the breaker is turned off and power is disconnected, by means of a two-pin electrical tester. Find the black wire into the ceiling junction box. Press one branch of the tester to the black wire, and the other branch to something metal on the junction box. The tester should not light if the power is off properly.
Install a flush mount ceiling light, Secure the rack bar to the electrical box in the ceiling. The fixture cross bar is a flat piece of metal 4 inches long and 1 cm wide with a plurality of openings cut into it. Wire bottom of the flush mount light. With a partner holding the base, connect the black wires from the light fixture to the black wire from the junction box, using an orange wire connector. Repeat this connection to the white wire from the fixture and the white wire from the junction box.
Connect the bare copper wire from the junction box to the green ground wire on the lamp with an orange wire connector. Attach the flush mount light base to the bar with screws from the light fixtures mounting bracket. Install light bulbs and light shaded according to the manufacturer’s instructions. Turn the flush mount ceiling light circuit by turning the switch on the main electrical panel.